Messages and Online Forum Q&A

Re: Cost of Blocking a Doorway

Category: Structural
Remote Name: 212.30.5.243
Date: 18 Jan 2006
Time: 01:22 PM

Comments

Question: I was wondering how much it would cost to "block up" an existing doorway, in a cavity wall...blocks are 9x4 on both sides...it is just an average height and width UPVC door that's there at present. The outside wall is rough rendered and the inside wall is plastered....a rough guide would be appreciated...many thanks !

Builders Websource® Answer: The price of labor varies greatly from location to location. However, we would estimate that such a job would cost between $1,000 - $2,000 including re-plastering. If you're handy, we'd recommend doing the painting yourself, particularly if it's a small area. Consider that this project will take a few trips: At least one to set the blocks, another 1-2 trips to plaster, and another 1-2 trips to repaint if you don't do it yourself. Get a few different bids and compare the prices. Make sure the wall is properly reinforced and filled with grout. Always hire a licensed contractor and check out the references and license status with your state contractor's board.

Builders Websource®

Article Tools

Builders Websource® is a corporate member of ASTM International—a non-profit engineering body dedicated in part to the standardization of building materials specifications, products, systems, and test methods for improved health, safety, and reliability of residential and commercial structures.

Copyright © 1999 - 2008 Builders Websource®, an InBuild™ company. All rights reserved.