Messages and Online Forum Q&A

Re: basements

From: info@builderswebsource.com
Category: Plumbing
Remote Name: 63.198.181.43
Date: 13 Jun 2001
Time: 09:44 PM

Comments

Assuming your existing drain is "cast iron" (black on the outside), you can add extend your drain by adding a "wye" using no-hub type rubber connectors with steel hose clamps tightened by hex nuts. Then, from there, you can continue with cast iron, or use ABS plastic to connect your new sink and shower. You must make sure you properly vent the new connections and that you maintain proper slope. You also need to make sure that the existing drain diameter is big enough to handle the sink and shower. If it's an old home, chances are the drain pipe is 3 or 4 inches in diameter, which should be OK.

If you have any doubts about how to do this or you don't have the right tools for the job, we recommend hiring a professional plumber who will make certain that you won't face any drainage problems down the road. This can be tricky to do right and you might end up spending more money on tools that it would cost to just have it done professionally. Good luck.

Builders Websource

Article Tools

Builders Websource® is a corporate member of ASTM International—a non-profit engineering body dedicated in part to the standardization of building materials specifications, products, systems, and test methods for improved health, safety, and reliability of residential and commercial structures.

Copyright © 1999 - 2008 Builders Websource®, an InBuild™ company. All rights reserved.