Messages and Online Forum Q&A

Offset hinges

From: skhebert@email.com
Category: Cabinetry
Date: 18 Jun 2000
Time: 11:54:01
Remote Name: 209.191.74.70

Comments

I painted dark stained (early 70's) kitchen cabinets. My old hinges were 3/8 offset but not self-closing. The screw holes seemed to match when I compared the hinges. I mounted all 53 new 3/8 offset hinges on the doors, using the old screw holes and the new hinge fits flush into the offset. When I tried to install them onto the cabinet, I discover the hinge is slightly flexed. When I used the original cabinet face screw holes, the hinge flange flattened as I tightened the screws and forced the door slightly over, away from the hinged side. Because of the offset, the doors now would not close correctly. So far I have only been able to get them to semi fit by holding the hinge slightly open (with a piece of stiff wire) ; holding the doors in place because of the offset; remarking the screw holes on the cabinet face and hoping the offset portion of the door will end up where it is suppose to be. - 10 hours and 5 doors are hung but still not the way they should be. What am I doing wrong? There are 18 more --some single (offset all the way around) and some double (straight cut where the doors meet). What is the correct procedure? Any help would be appreciated Thank you Sandy

Article Tools

Builders Websource® is a corporate member of ASTM International—a non-profit engineering body dedicated in part to the standardization of building materials specifications, products, systems, and test methods for improved health, safety, and reliability of residential and commercial structures.

Copyright © 1999 - 2018 Builders Websource®, a BUILDERA™ company. All rights reserved.